Lo-Chlor Swimming Pool Leak Sealer - 1 Litre

Based on 0 reviews. - Write a review

£29.95

Stock: In Stock
Model: 1lt
Weight: 1.00kg
SKU: 5L-VFW5-J5F3
MPN: LCC-500-0505

Lo-Chlor

Add to Cart

Buy Now Ask Question

Add to Wish List Compare this Product

Lo-Chlor Leak Sealer

Specifically designed to seal minor leaks in swimming pools

First option prior to spending excessive amounts on leak detection and possible major structural work

Designed to be used with a water loss not exceeding 1 inch per day in a 60,000 litre pool

General
Dose rate	<p>1 Litre treats 60,000 litres (13,500 gallons).</p>
Instructions	<p><strong>Please note: Leak Sealer should not be used when the swimming pool water temperature is below 6 degrees Celsius (°C).</strong></p> <p>Turn pool pump off. Remove any automatic pool cleaner from the pool.</p> <p>Set the filter on BY-PASS or RECIRCULATE setting. If neither of these settings are available, then remove the filter grids or cartridges from the filter prior to commencing treatment.<br> <strong>Note:</strong> Fine fountain jets may block when Leak Sealer is applied. If these jets cannot be removed prior to use, then do not use this product.</p> <p>Leak Sealer should be added to the pool at the rate of 1 litre per 60,000 litres pool water. There are two methods of application for Leak Sealer depending on the location of the leak.<br> <strong>(A) LEAK IN POOL SURFACE:</strong> If possible locate the area of the leak and add the product to this area. Otherwise distribute the product evenly around the pool.<br> <strong>(B) LEAK IN PIPEWORK:</strong> Add the correct dose directly into the skimmer. Set up a pool vacuum hose (with vacuum head attached) at the deepest point of the pool (This method ensures maximum circulation through the pipe-work). Check that the vac hose is free of air before application.</p> <p>If uncertain of the location of the leak use the above method (B).</p> <p>Wait 30 minutes and then turn the pump on. Leave the pump running for a minimum of 8 hours.</p> <p>Mark the water level and check in 24 hours.</p> <p>Leave the pool until all residue settles (within 6 hours) and vacuum any residue to waste.</p> <p>A second application may be required in larger pools or if the loss of water has been reduced.</p> <p>Please note: Leak Sealer should not be used when the swimming pool water temperature is below 6 degrees Celsius, and is not recommended to repair torn vinyl liners.</p>

Lo-Chlor Swimming Pool Leak Sealer - 1 Litre

Write a review

Information

My Account

Customer Service